For many years, I set up my dado stack directly on my table saw. So if my test cut was not correct, it required the re- moval of a portion of the set to add or remove shims, or swap out one of the chippers until I was satisfied.
I thought, how great would it be if I could accurately measure the setup be- fore it was mounted it on the saw’s arbor?
So I made an “Easy-Set Jig,” with a 3⁄4″-thick circle that’s smaller than the diameter of the dado blades, attached to a base with a through-bolt. After tightening the 5⁄8″ x 21⁄2″ bolt, the circle lifts the stack sufficiently to measure with calipers the full width of the teeth at any place along the circumference.
With this jig, I can test the setup before loading the dado stack onto the table saw.
I added a short bolt at the top to store my extra shims. –Dennis Snyder
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
… Continue Reading at: www.popularwoodworking.com [source]