http://www.AsWoodTurns.com
A DIY project to provide LED light to my wood lathe. The LED’s were purchased from Ikea; The magnet was purchased from Harbor Freight. I woodturned small bases to hold the light and the magnet.
Both were turned from scrap offcuts: one is russian olive, the other is aspen.
Before turning, I drilled holes to match the bottom of the LED light. Then the bottoms were turned first to make a recess for the magnet and recess to use to remount onto a chuck. They are finished with a mix of mineral oil and beeswax. Tools used were a bowl gouge and a bedan.

Likes: 10

Viewed:

source